H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-44
Examples
# Configure a name for the local IS.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] is-name RUTA
4.1.41 is-name map
is-name map sys-id map-sys-name
undo is-name map sys-id
View
IS-IS view
Parameters
sys-id: System ID or a pseudonode ID of a remote IS.
map-sys-name: Specifies a name for the remote IS, a string of 1 to 64 characters.
Description
Use the is-name map command to map a name to a remote IS. Each remote IS
system ID corresponds to only one name.
Use the undo is-name map command to remove the configuration.
By default, no name is configured for a remote IS.
Examples
# Map the name RUTB to the remote IS 0000.0000.0041.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] is-name map 0000.0000.0041 RUTB
4.1.42 is-snmp-traps enable
Syntax
is-snmp-traps enable
undo is-snmp-traps
View
IS-IS view