H3C S7500E Series

Command Manual – QinQ-BPDU Tunneling
H3C S7500E Series Ethernet Switches Chapter 1 QinQ Configuration Commands
1-4
[Sysname-Ethernet2/0/2] interface ethernet 2/0/3
[Sysname-Ethernet2/0/3] port link-aggregation group 1
[Sysname-Ethernet2/0/3] quit
[Sysname] port-group aggregation 1
[Sysname-port-group-aggregation-1] qinq enable
1.1.5 qinq ethernet-type customer-tag
Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag
View
System view
Parameters
hex-value: Hexadecimal protocol type ID, in the range of 0x0001 to 0xFFFF, but you
cannot set it to any of the protocol type values listed in
Table 1-1.
Table 1-1 Common protocol type values
Protocol type Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86DD
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1x 0x888E
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF