H3C S7500E Series

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-37
Examples
# Set the AC input under-voltage threshold to 181 V.
<Sysname> system-view
[Sysname] poe-power input-threshold lower 181
# Set the AC input over-voltage threshold to 264 V.
<Sysname> system-view
[Sysname] poe-power input-threshold upper 264
1.1.33 poe-power output-threshold
Syntax
poe-power output-threshold { lower | upper } value
undo poe-power output-threshold { lower | upper }
View
System view
Parameters
lower value: Specifies an under-voltage threshold in volts, in the range 45 to 47, with
the default value being 45.
upper value: Specifies an over-voltage threshold in volts, in the range 55 to 57, with the
default value being 57.
Description
Use the poe-power output-threshold command to configure a DC output
under-voltage/over-voltage threshold.
Use the undo poe-power output-threshold command to restore the default.
Examples
# Set a DC output under-voltage threshold to 45 V.
<Sysname> system-view
[Sysname] poe-power output-threshold lower 45
# Set a DC output over-voltage threshold to 57 V.
<Sysname> system-view
[Sysname] poe-power output-threshold upper 57