Command Manual – QinQ-BPDU Tunneling
H3C S7500E Series Ethernet Switches Chapter 1 QinQ Configuration Commands
1-3
Related commands: qos policy, traffic behavior.
Examples
# Configure the action of creating outer VLAN tag 100 for the traffic behavior database.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] nest top-most vlan-id 100
1.1.4 qinq enable
Syntax
qinq enable
undo qinq enable
View
Ethernet port view, port group view
Parameters
None
Description
Use the qinq enable command to enable basic QinQ for the current Ethernet port.
Use the undo qinq enable command to disable basic QinQ for the current Ethernet
port.
By default, basic QinQ is disabled for Ethernet port.
After basic QinQ is enabled on the port, frames on this port will be tagged with a new
VLAN tag, the VLAN ID in which is the default VLAN ID of the port.
Configured in Ethernet port view, the setting is effective on the current port only;
configured in port group view, the setting is effective on all ports in the port group.
Examples
# Enable basic QinQ on port Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] qinq enable
# Enable basic QinQ on all the ports in port group 1.
<Sysname> system-view
[Sysname] link-aggregation group 1 mode manual
[Sysname] interface ethernet 2/0/2
[Sysname-Ethernet2/0/2] port link-aggregation group 1
To Next Page
Loading...
Need help?
General
