Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-13
View
System view
Parameters
None
Description
Use the info-center enable command to enable information center.
Use the undo info-center enable command to disable the information center.
The system outputs information to the log host or the console only after the information
center is enabled first.
By default, the information center is enabled.
Examples
# Enable the information center.
<Sysname> system-view
[Sysname] info-center enable
% Information center is enabled
1.1.11 info-center logbuffer
Syntax
info-center logbuffer [ channel { channel-number | channel-name } | size buffersize ]
*
undo info-center logbuffer [ channel | size ]
View
System view
Parameters
buffersize: Specifies the maximum number of log messages in a log buffer, in the range
0 to 1,024 with 512 as the default value.
channel-number: A specified channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
To Next Page
Loading...
Need help?
General
