Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-32
1.1.26 poe power max-value
Syntax
poe power max-value max-power
undo poe power max-value
View
System view
Parameters
max-power: Maximum PoE power, namely, maximum power that the device can
provide for all PSEs. In consideration of the transient peak power effect, the maximum
power available is 5% higher than the configured maximum power. The range, default
value, granularity, and limit vary with devices.
Description
Use the poe power max-value command to configure the maximum PoE power.
Use the undo poe power max-value command to restore the default.
Note that the configured maximum PoE power cannot exceed the rated PoE power.
Examples
# Set the maximum PoE power to 1,000 watts for the device.
<Sysname> system-view
[Sysname] poe power max-value 1000
1.1.27 poe priority
Syntax
poe priority { critical | high | low }
undo poe priority
View
PoE interface view, PoE-profile file view
Parameters
critical: Sets the power priority of a PoE interface to critical. The PoE interface whose
power priority level is critical works in guaranteed mode, that is, power is first supplied
to the PD connected to this critical PoE interface.
high: Sets the power priority of a PoE interface to high.
low: Sets the power priority of a PoE interface to low.
To Next Page
Loading...
Need help?
General
