H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-16
1.1.17 parity
Syntax
parity { even | mark | none | odd | space }
undo parity
View
AUX interface view
Parameters
even: Performs even checks.
mark: Performs mark checks.
none: Does not check.
odd: Performs odd checks.
space: Performs space checks.
Description
Use the parity command to set the check mode of the user interface.
Use the undo parity command to revert to the default check mode.
No check is performed by default.
 Note:
H3C S7500E series Ethernet switches support the even, none, and odd check modes
only. To establish the connection again, you need to modify the configuration of the
termination emulation utility running on your PC accordingly.
Examples
# Set to perform mark checks.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] parity mark
1.1.18 protocol inbound
Syntax
protocol inbound { all | ssh | telnet }

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English