H3C S7500E Series

Command Manual – NTP
H3C S7500E Series Ethernet Switches Chapter 1 NTP Configuration Commands
1-7
undo ntp-service authentication enable
View
System view
Parameters
None
Description
Use the ntp-service authentication enable command to enable NTP authentication.
Use the undo ntp-service authentication enable command to disable NTP
authentication.
By default, NTP authentication is disabled.
Examples
# Enable NTP authentication.
<Sysname> system-view
[Sysname] ntp-service authentication enable
1.1.6 ntp-service authentication-keyid
Syntax
ntp-service authentication-keyid keyid authentication-mode md5 value
undo ntp-service authentication-keyid keyid
View
System view
Parameters
keyid: Authentication key ID, in the range of 1 to 4294967295.
authentication-mode md5 value: Specifies to use the MD5 algorithm for key
authentication, where value represents authentication key and is a string of 1 to 32
characters.
Description
Use the ntp-service authentication-keyid command to set the NTP authentication
key.
Use the undo ntp-service authentication-keyid command to remove the set NTP
authentication key.