H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-1
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
 Note:
The term “router” in this document refers to a router in the generic sense or a Layer 3
switch running an IP multicast routing protocol.
6.1 Multicast Routing and Forwarding Configuration
Commands
6.1.1 display multicast boundary
Syntax
display multicast boundary [ group-address [ mask | mask-length ] ] [ interface
interface-type interface-number ]
View
Any view
Parameters
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
mask: Mask of the multicast group address, 255.255.255.255 by default.
mask-length: Mask length of the multicast group address, in the range of 4 to 32. The
system default is 32.
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display multicast boundary command to view the multicast boundary
information on the specified interface or all interfaces.
Related commands: multicast boundary.
Examples
# View the multicast boundary information on all interfaces.
<Sysname> display multicast boundary