H3C S7500E Series Command Manual

Command Manual – SSH
H3C S7500E Series Ethernet Switches Chapter 1 SSH Configuration Commands
1-24
Description
Use the ssh server enable command to enable SSH server.
Use the undo ssh server enable command to disable SSH server.
By default, SSH server is disabled.
Examples
# Enable SSH server.
<Sysname> system-view
[Sysname] ssh server enable
1.1.30 ssh server rekey-interval
Syntax
ssh server rekey-interval hours
undo ssh server rekey-interval
View
System view
Parameters
hours: Server key pair update interval in hours, in the range 1 to 24.
Description
Use the ssh server rekey-interval command to set the interval for updating the RSA
server key.
Use the undo ssh server rekey-interval command to remove the configuration.
By default, the update interval of the RSA server key is 0, that is, the RSA server key is
not updated.
Related commands: display ssh server.
Caution:
This command is only available to SSH users using SSH1 client software.
Examples
# Set the RSA server key pair update interval to three hours.
<Sysname> system-view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English