H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration Commands
3-4
Table 3-1 Description on fields of the display interface tunnel command
Field Description
Tunnel1/0/3 current state: UP
The physical layer protocol state of the tunnel
interface.
Line protocol current state: UP
The link layer protocol state of the tunnel
interface.
Description Descriptive information of a tunnel interface
Tunnel1/0/3 Interface Tunnel interface number
Maximum Transmit Unit Maximum transmission unit (MTU) in a tunnel
Encapsulation is TUNNEL The encapsulation protocol is tunnel.
Aggregation ID
Link aggregation group ID referenced by a
tunnel. If the device supports link aggregation
groups, the link aggregation group ID configured
in tunnel interface view is displayed. If device
does not support, “aggregation ID not set” is
displayed.
Tunnel source Tunnel source address
Destination Tunnel destination address
Tunnel protocol/transport Tunnel protocol and transport protocol.
Last 300 seconds input
Number of bytes and packets input per second
in the last five minutes.
Last 300 seconds output
Number of bytes and packets output per second
in the last five minutes.
packets input Total number of input packets.
input error
Number of error packets among all input
packets.
packets output Total number of output packets.
output error Number of error packets in all output packets
3.1.4 display ipv6 interface tunnel
Syntax
display ipv6 interface tunnel number
View
Any view
Parameters
number: Tunnel interface number.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English