Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-33
Description
Use the poe priority command to configure a power priority level for a PoE interface.
Use the undo poe priority command to restore the default.
By default, the power priority of a PoE interface is low.
Note that:
z When the PoE power is insufficient, power is first supplied to PoE interfaces with a
higher priority level.
z If a PoE configuration file is already applied to a PoE interface, you need to
remove the application of the file to the PoE interface before configuring the
interface in PoE-profile view.
z If a PoE configuration file is applied to a PoE interface, you need to remove the
application of the file to the PoE interface before configuring the interface in PoE
interface view.
z If two PoE interfaces have the same priority level, the PoE interface with a smaller
ID has the higher priority level.
Examples
# Set the power priority of Ethernet 2/0/2 to critical.
<Sysname> system-view
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] poe priority critical
# Set the power priority of Ethernet 2/0/2 to critical through a PoE configuration file.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe priority critical
[Sysname-poe-profile-abc-1] quit
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] apply poe-profile name abc
1.1.28 poe priority (system view)
Syntax
poe priority { critical | high | low } [ pse pse-id ]
undo poe priority [ pse pse-id ]
View
System view
To Next Page
Loading...
Need help?
General
