Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 2 FTP Configuration Commands
2-4
Parameters
minute: Idle-timeout timer in minutes, in the range 1 to 35791. The default is 30
minutes.
Description
Use the ftp timeout command to set the idle-timeout timer.
Use the undo ftp timeout command to restore the default.
After you log onto the FTP server, you set up an FTP connection. When the connection
is disrupted, the FTP server, if not notified, cannot realize that and maintains the
connection all the same. To address this problem, you can set an idle-timeout timer to
have the FTP server disconnected if no information is received or/and transmitted
before the timer expires.
Examples
# Set the idle-timeout timer to 36 minutes.
<Sysname> system-view
[Sysname] ftp timeout 36
2.1.6 ftp update
Syntax
ftp update { fast | normal }
undo ftp update
View
System view
Parameters
fast: Fast update.
normal: Normal update.
Description
Use the ftp update command to set the file update mode that the FTP server uses
while receiving data.
Use the undo ftp update command to restore the default, namely, the normal mode.
Examples
# Set the FTP update mode to normal.
<Sysname> system-view
[Sysname] ftp update normal
To Next Page
Loading...
Need help?
General
