To Next Page

To Previous Page

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands

3-57

Examples

# Make RFC1583 routing rules compatible.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] rfc1583 compatible

3.1.56 silent-interface

Syntax

silent-interface { all | interface-type interface-number }

undo silent-interface { all | interface-type interface-number }

View

OSPF view

Parameters

all: Disables all interfaces from sending OSPF packets.

interface-type interface-number: Interface type and interface number.

Description

Use the silent-interface command to disable an interface or all interfaces from

sending OSPF packets.

Use the undo silent-interface command to restore the default.

By default, an interface sends OSPF packets.

A disabled interface is a passive interface, which cannot send any hello packet.

To make no routing information obtained by other routers on a network segment, you

can use this command to disable the interface from sending OSPF packets.

Examples

# Disable an interface from sending OSPF packets.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] silent-interface vlan-interface 10

3.1.57 snmp-agent trap enable ospf

Syntax

snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt |

ifstatechange | iftxretransmit | lsdbapproachoverflow | lsdboverflow | maxagelsa

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series