H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-41
4.1.44 pim sm
Syntax
pim sm
undo pim sm
View
Interface view
Parameters
None
Description
Use the pim sm command to enable PIM-SM.
Use the undo pim sm command to disable PIM-SM.
By default, PIM-SM is disabled.
Related commands: pim dm.
Examples
# Enable PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim sm
4.1.45 pim state-refresh-capable
Syntax
pim state-refresh-capable
undo pim state-refresh-capable
View
Interface view
Parameters
None
Description
Use the pim state-refresh-capable command to enable the state fresh feature on the
interface.
Use the undo pim state-refresh-capable command to disable the state fresh feature.