Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-16
Parameters
aa:nn: Specifies a community number; both aa and nn are in the range 0 to 65535.
&<1-13>: Indicates the argument before it can be entered up to 13 times.
no-advertise: Displays routes not advertised to any peer.
no-export: Displays routes advertised outside the AS; if there is a confederation, it
displays routes not advertised outside the confederation, but to other sub ASs in the
confederation.
no-export-subconfed: Displays routes neither advertised outside the AS nor to other
sub ASs if the confederation is configured.
whole-match: Displays the exactly matched routes.
Description
Use the display bgp ipv6 routing-table community command to display the routing
information of the specified community.
Examples
# Display the routing information of the community no-export.
<Sysname> display bgp ipv6 routing-table community no-export
BGP Local router ID is 30.30.30.1
Status codes: * - valid, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
*> Network : 30:30:: PrefixLen : 64
NextHop : 30:30::30:1 LocPrf :
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: i
Refer to Table 5-5 for description on the fields above.
5.1.17 display bgp ipv6 routing-table community-list
Syntax
display bgp ipv6 routing-table community-list { basic-community-list-number
[ whole-match ] | adv-community-list-number }&<1-16>
View
Any view
To Next Page
Loading...
Need help?
General
