Command Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands
1-9
Field Description
Port status
Port status includes down, up and blocked; “-“ appears in
one of the following cases:
z the ring is inactive
z the port is not configured on the ring
z the board to which the port belongs does not start
1.1.5 reset rrpp statistics
Syntax
reset rrpp statistics domain domain-id [ ring ring-id ]
View
User view
Parameters
domain-id: RRPP domain ID, in the range 1 to 8.
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the reset rrpp statistics command to clear RRPP message statistics.
If you have specified an RRPP ring ID in the command, RRPP message statistics of the
specified RRPP ring in the specified RRPP domain on the current device is cleared.
Otherwise, RRPP message statistics of all RRPP rings in the specified RRPP domain is
cleared.
Related commands: display rrpp statistics.
Examples
# Clear the RRPP message statistics of ring 10 in RRPP domain 10.
<Sysname> reset rrpp statistics domain 1 ring 10
1.1.6 ring
Syntax
ring ring-id node-mode { { master | transit } [ primary-port interface-type
interface-number ] [ secondary-port interface-type interface-number ] level
level-value | { edge | assistant-edge } [ common-port interface-type
interface-number ] [ edge-port interface-type interface-number ] }
undo ring ring-id
To Next Page
Loading...
Need help?
General
