H3C S7500E Series

Command Manual – ACL
H3C S7500E Series Ethernet Switches Chapter 1 ACL Configuration Commands
1-3
Table 1-1 Description on the fields of the display acl resource command
Field Description
Interface Interface indicated by its type and number
Type
Resource type:
z ACL indicates ACL rule resources,
z Meter indicates traffic policing resources,
z Counter indicates traffic statistics resources,
z IFP indicates the count of resources in the inbound direction,
z EFP indicates the count of resources in the outbound direction
z VFP indicates the count of resources that are before Layer 2
forwarding and applied in QinQ.
Total Total number of ACLs supported
Reserved Number of reserved ACLs
Configured Number of configured ACLs
Remaining Number of remaining ACLs
1.1.2 display time-range
Syntax
display time-range { time-name | all }
View
Any view
Parameters
time-name: Time range name comprising 1 to 32 characters. It is case insensitive and
must start with an English letter. To avoid confusion, this name cannot be all.
all: All existing time ranges.
Description
Use the display time-range command to display the configuration and state of a
specified or all time ranges.
A time range is active if the system time falls into its range, and if otherwise, inactive.
Examples
# Display the configuration and state of time range trname.
<Sysname> display time-range trname
Current time is 22:20:18 1/5/2006 Thursday