H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-1
Chapter 1 VRRP Configuration Commands
 Note:
At present, the interfaces that VRRP involves can only be VLAN interfaces unless
otherwise specified.
1.1 IPv4-Based VRRP Configuration Commands
1.1.1 display vrrp
Syntax
display vrrp [ verbose ] [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
Any view
Parameters
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its type
and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the display vrrp command to display the state information of VRRP.
If you do not specify verbose, only the brief state information of VRRP is displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify neither,
the state information of all the standby groups on the device is displayed.
Examples
# Display brief information about all standby groups on the device.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English