Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-14
Description
Use the multicast forwarding-table downstream-limit command to configure the
maximum number of downstream nodes for a single route in the multicast forwarding
table.
Use the undo multicast forwarding-table downstream-limit command to restore the
system default.
By default, the maximum number of downstream nodes for a single route in the
multicast forwarding table is 128.
Related commands: display multicast forwarding-table.
Examples
# Set the maximum number of downstream nodes for a single route in the multicast
forwarding table to 120.
<Sysname> system-view
[Sysname] multicast forwarding-table downstream-limit 120
6.1.10 multicast forwarding-table route-limit
Syntax
multicast forwarding-table route-limit limit
undo multicast forwarding-table route-limit
View
System view
Parameters
limit: Maximum number of route entries in the multicast forwarding table. The value
ranges 0 to the maximum allowable number.
Description
Use the multicast forwarding-table route-limit command to configure the maximum
number of route entries in the multicast forwarding table.
Use the undo multicast forwarding-table route-limit command to restore the
maximum number of route entries in the multicast forwarding table to the system
default.
By default, the maximum number of route entries in the multicast forwarding table is
1000.
Related commands: display multicast forwarding-table.
To Next Page
Loading...
Need help?
General
