Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-7
Preference = 1, Order = 1
Running Configuration = ip rpf-route-static 10.10.0.0 16 2.2.2.2 order 1
# View the configuration information of multicast static routes.
<Sysname> display multicast routing-table static config
Multicast Routing Table
Routes : 1
Mroute 10.10.0.0/16, interface = Vlan-interface1
Matched routing protocol = <none>, Route-policy = <none>
Preference = 1, Order = 1
Table 6-5 Description on the fields of display multicast routing-table static
Field Description
Mroute Multicast route source address and its mask length
Interface Outgoing interface to the multicast source
RPF Neighbor
IP address of the RPF neighbor through which the
multicast source is reachable
Matched routing protocol
If a protocol is configured, the multicast source
address of the route should be the destination
address of an entry in unicast routing table.
Route-policy
Routing policy. The multicast source address of the
route should match the routing policy.
Preference Route preference
Order Sequence number of the route
6.1.5 display multicast rpf-info
Syntax
display multicast rpf-info source-address [ group-address ]
View
Any view
Parameters
source-address: Multicast source address.
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
To Next Page
Loading...
Need help?
General
