H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 2 HA Configuration Commands
2-3
Description
Use the slave auto-update config command to enable automatic synchronization of
the configuration file on the AMB and SMB.
Use the undo slave auto-update config command to disable automatic
synchronization of the configuration file on the AMB and SMB.
By default, automatic synchronization of the configuration file on the AMB and SMB is
enabled.
Examples
# Enable automatic synchronization of the configuration file on the AMB and SMB.
<Sysname> system-view
[Sysname] slave auto-update config
2.1.4 slave restart
Syntax
slave restart
View
System view
Parameters
None
Description
Use the slave restart command to manually configure the SMB to restart.
When the backup system program operates abnormally and needs to be reloaded, you
can manually restart the SMB.
Examples
# Restart the SMB.
<Sysname> system-view
[Sysname] slave restart
The slave will reset! Continue?[Y/N]:y
2.1.5 slave switchover
Syntax
slave switchover

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English