H3C S7500E Series

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management Commands
3-27
Table 3-12 Default working mode of EA LPUs
SRPU model
Current traffic
forwarding mode of the
SRPU
Default working mode
of EA LPUs
LSQ1SRP2XB,
LSQ1SRPB, LSQ1MPUA
l2-enhanced or standard
routing
l2-enhanced or
standard-bridging
bridging
LSQ1SRP1CB
standard-routing routing
 Note:
z When the SRPU of the S7500E switch is LSQ1SRP1CB, it is recommended not to
modify the default working mode the EA LPUs.
z When the SRPU of the S7500E switch is LSQ1SRP2XB, LSQ1SRPB, or
LSQ1MPUA, if an EA LPU is connected to a Layer 2 forwarding network with a large
number of MAC addresses, you can configure the EA LPU to work in the MAC
extension mode.
z To make the configured working mode take effect, you need to save the
configuration and restart the switch.
Examples
# Configure the working mode of the EA LPU on slot 2 of the S7502E switch as the
MAC extension mode.
<Sysname> system-view
[Sysname] switch-mode bridging slot 2
# Restore the default working mode of the EA LPU on slot 2 of the S7502E switch.
<Sysname> system-view
[Sysname] undo switch-mode slot 2
3.1.24 temperature-limit
Syntax
temperature-limit slot-number lower-value upper-value
undo temperature-limit slot-number
View
System view