Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-16
1.2.2 display vrrp ipv6 statistics
Syntax
display vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
Any view
Parameters
interface interface-type interface-number: Displays VRRP statistics information of the
specified interface. interface-type interface-number specifies an interface by its type
and number.
vrid virtual-router-id: Displays statistics information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the display vrrp ipv6 statistics command to display statistics about VRRP for
IPv6.
If you specify both interface and standby group, only the statistics about the specified
standby group are displayed; if you only specify an interface, the statistics about all the
standby groups on the interface are displayed; if you specify neither, the statistics about
all the standby groups on the device are displayed.
Examples
# Display the statistics about all standby groups for IPv6.
<Sysname> display vrrp ipv6 statistics
Interface : Vlan-interface100
VRID : 80
CheckSum Errors : 0 Version Errors : 0
Invalid Type Pkts Rcvd : 0 Advertisement Interval Errors : 0
Hop Limit Errors : 0 Auth Failures : 0
Invalid Auth Type : 0 Auth Type Mismatch : 0
Packet Length Errors : 0 Address List Errors : 0
Become Master : 1 Priority Zero Pkts Rcvd : 0
Advertise Rcvd : 0 Priority Zero Pkts Sent : 0
Advertise Sent : 20
Interface : Vlan-interface200
VRID : 10
CheckSum Errors : 0 Version Errors : 0
To Next Page
Loading...
Need help?
General
