H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-22
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf nexthop command to display OSPF next hop information.
If no OSPF process is specified, the next hop information of all OSPF processes is
displayed.
Examples
# Display OSPF next hop information.
<Sysname> display ospf nexthop
OSPF Process 1 with Router ID 192.168.0.1
Routing Nexthop Information
Next Hops:
Address Refcount IntfAddr Intf Name
----------------------------------------------------------------
192.168.0.1 1 192.168.0.1 Vlan-interface1
192.168.0.2 1 192.168.0.1 Vlan-interface1
192.168.1.1 1 192.168.1.1 Vlan-interface10
Table 3-9 Description on the fields of the display ospf nexthop command
Field Description
Next hops Information about Next hops
Address Next hop address
Refcount Reference count, namely, routes that reference the next hop
IntfAddr Outbound interface address
Intf Name Outbound interface name
3.1.18 display ospf peer
Syntax
display ospf [ process-id ] peer [ verbose | [ interface-type interface-number ]
[ neighbor-id ] ]

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English