Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-7
Field Description
Hosts use stateless autoconfig for
addresses
Hosts use stateless auto-configuration
mode to acquire IPv6 addresses
# Display the brief IPv6 information of all interfaces for which IPv6 addresses can be
configured.
<Sysname> display ipv6 interface brief
*down: administratively down
(s): spoofing
Interface Physical Protocol IPv6 Address
Vlan-interface1 down down Unassigned
Vlan-interface2 up up 2001::1
Vlan-interface100 up down Unassigned
Table 1-6 Description on fields of display ipv6 interface brief
Field Description
*down
The interface is down, that is, the interface is closed by using
the shutdown command.
(s)
Spoofing attribute of the interface, that is, the link protocol state
of the interface is up, but the link does not exist, or the link is
established on demand, instead of being permanent.
Interface Name of the interface
Physical Physical state of the interface
Protocol Link protocol state of the interface
IPv6 Address
IPv6 address of the interface. Only the first of configured IPv6
addresses is displayed. (If no address is configured for the
interface, “Unassigned” will be displayed.)
1.1.6 display ipv6 neighbors
Syntax
display ipv6 neighbors { { ipv6-address | all | dynamic | static } [ slot slot-number ] |
interface interface-type interface-number | vlan vlan-id } [ | { begin | exclude | include }
text ]
View
Any view
To Next Page
Loading...
Need help?
General
