Command Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands
1-14
Parameters
None
Description
Use the rrpp enable command to enable RRPP protocol.
Use the undo rrpp enable command to disable RRPP protocol.
By default, RRPP protocol is disabled.
To activate the RRPP domain, RRPP protocol and the RRPP ring must be enabled
simultaneously.
Related commands: ring enable.
Examples
# Enable RRPP protocol
<Sysname> system-view
[Sysname] rrpp enable
1.1.10 timer
Syntax
timer hello-timer hello-value fail-timer fail-value
undo timer
View
RRPP domain view
Parameters
hello-value: Hello timer value, in the range 1 to 10 seconds.
fail-value: Fail timer value, in the range 3 to 30 seconds.
Description
Use the timer command to specify the value of the timers of the RRPP domain.
Use the undo timer command to restore it to the default value.
By default, the Hello timer value is 1 second and the Fail timer value is 3 seconds.
Note that the Fail timer value must be greater than or equal to three times of the Hello
timer value.
Examples
# Set the Hello timer value to 2 seconds and the Fail timer value to 7 seconds.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
