H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-41
4.1.37 isis timer lsp
Syntax
isis timer lsp time [ count count ]
undo isis timer lsp
View
Interface view
Parameters
time: Specifies the minimum interval in milliseconds for sending link-state packets,
ranging from 1 to 1000.
count: Specifies the maximum number of link-state packets to be sent at one time, in
the range of 1 to 1000. The default is 100 for the broadcast interface and 11 for
point-to-point interface.
Description
Use the isis timer lsp command to configure the interval for sending link-state packets
on the interface.
Use the undo isis timer lsp command to restore the default of 33 ms.
Related commands: isis timer retransmit.
 Note:
This command is not available in loopback interface view.
Examples
# Configure the interval as 500 milliseconds for sending LSPs on interface
VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis timer lsp 500
4.1.38 isis timer retransmit
Syntax
isis timer retransmit seconds
undo isis timer retransmit