Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-6
Description
Use the apply extcommunity command to apply the specified extended community
attribute to BGP routes.
Use the undo apply extcommunity command to remove the clause configuration.
No extended community attribute is set for routing information by default.
Examples
# Create routing policy policy1 with node 10, matching mode as permit. If a BGP route
matches AS-path-ACL 1, add the RT extended community attribute 100:2 to the route.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply extcommunity rt 100:2 additive
6.1.7 apply isis
apply isis { level-1 | level-1-2 | level-2 }
undo apply isis
View
Routing policy view
Parameters
level-1: Redistributes routes into IS-IS level-1 area.
level-2: Redistributes routes into IS-IS level-2 area.
level-1-2: Redistributes routes into both IS-IS level-1 and level-2 areas.
Description
Use the apply isis command to redistribute routes into a specified ISIS level.
Use the undo apply isis command to remove the clause configuration.
No level is set by default.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply cost, apply origin, apply
tag.
Examples
# Create routing policy policy1 with node 10, matching mode as permit. If a route
matches tag 8, redistribute the route to IS-IS level-2 area.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
To Next Page
Loading...
Need help?
General
