H3C S7500E Series Command Manual

Command Manual – MSTP
H3C S7500E Series Ethernet Switches Chapter 1 MSTP Configuration Commands
1-1
Chapter 1 MSTP Configuration Commands
1.1 MSTP Configuration Commands
1.1.1 active region-configuration
Syntax
active region-configuration
View
MST region view
Parameters
None
Description
Use the active region-configuration command to activate your MST region
configuration.
When you carry out this command, MSTP will replace the currently running MST
region–related parameters with the parameters you have just configured, and will
perform spanning tree calculation again.
Related commands: instance, region-name, revision-level, vlan-mapping modulo,
check region-configuration.
Examples
# Activate MST region configuration manually.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] active region-configuration
1.1.2 check region-configuration
Syntax
check region-configuration
View
MST region view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English