Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-34
Parameters
critical: Sets the power priority level of the PSE to critical. The PSE whose power
priority level is critical works in guaranteed mode, that is, power is first supplied to the
PSE.
high: Sets the power priority of the PSE to high.
low: Sets the power priority of the PSE to low.
pse pse-id: Specifies a PSE ID.
Description
Use the poe priority command to configure a power priority level for the PSE.
Use the undo poe priority command to restore the default.
By default, the power priority level of the PSE is low.
When the PoE power is insufficient, power is first supplied to PSE with a higher power
priority level.
Examples
# Set the power priority of PSE 7 to critical.
<Sysname> system-view
[Sysname] poe priority critical pse 7
1.1.29 poe pse-policy priority
Syntax
poe pse-policy priority
undo poe pse-policy priority
View
System view
Parameters
None
Description
Use the poe pse-policy priority command to configure a PSE power management
priority policy.
Use the undo poe pse-policy priority command to remove the PSE power
management priority policy.
By default, no PSE power management priority policy is configured.
To Next Page
Loading...
Need help?
General
