H3C S7500E Series

Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-12
2.2.7 remark customer-vlan-id
Syntax
remark customer-vlan-id vlan-id-value
undo remark customer-vlan-id
View
Traffic behavior view
Parameters
vlan-id-value: VLAN ID to be set for packets, in the range of 1 to 4094.
Description
Use the remark customer-vlan-id command to configure the action of setting the
customer network VLAN ID for a traffic behavior.
Use the undo remark customer-vlan-id command to remove the action of setting the
customer network VLAN ID.
Note that the action of setting the customer network VLAN ID cannot be applied to a
VLAN or applied globally.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action of setting the customer network VLAN ID to 2 for a traffic
behavior.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark customer-vlan-id 2
2.2.8 remark dot1p
Syntax
remark dot1p 8021p
undo remark dot1p
View
Traffic behavior view
Parameters
8021p: 802.1p precedence to be set for packets, in the range 0 to 7.