H3C S7500E Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management Commands
3-16
Table 3-8 Description on the fields of display transceiver alarm interface
Field Description
transceiver current alarm information
Current alarm information of the
transceiver
TX fault TX fault
3.1.14 display transceiver diagnosis interface
Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the display transceiver diagnosis interface command to display the currently
measured value of digital diagnosis parameters of a single or all anti-spoofing
transceivers customized by H3C.
Examples
# Display the currently measured value of digital diagnosis parameters of the
anti-spoofing pluggable optical transceiver customized by H3C on interface
GigabitEthernet 2/0/2.
<Sysname> display transceiver diagnosis interface gigabitethernet 2/0/2
GigabitEthernet2/0/2 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C) Voltage(V) Bias(mA) RX power(dBM) TX power(dBM)
36 3.31 6.13 -35.64 -5.19
Table 3-9 Description on the fields of display transceiver diagnosis interface
Field Description
transceiver diagnostic information
Digital diagnosis information of the transceiver
carried by an interface
Current diagnostic parameters Current diagnostic parameters
Temp(°C)
Digital diagnosis parameter-temperature, in
°C, with the precision to 1°C.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English