H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-13
Parameters
None
Description
Use the default-route imported command to allow default route redistribution into the
BGP routing table.
Use the undo default-route imported command to disallow the redistribution.
By default, default route redistribution is not allowed.
Using the default-route imported command cannot redistribute default routes. To do
so, use the import-route command.
Related commands: import-route.
Examples
# In BGP view, allow default route redistribution from OSPF into BGP.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default-route imported
[Sysname-bgp] import-route ospf 1
5.1.16 display bgp group
Syntax
display bgp group [ group-name ]
View
Any view
Parameters
group-name: Peer group name, a string of 1 to 47 characters.
Description
Use the display bgp group command to display the information of the peer group.
Examples
# Display the information of the peer group aaa.
<Sysname> display bgp group aaa
BGP peer-group is aaa
remote AS 200
Type : external