H3C S7500E Series

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-11
 Note:
You can remove an existing service loop group using the undo link-aggregation
group command. However, service loop groups currently referenced by modules
cannot be removed.
Examples
# Configure link aggregation group 5 as a tunnel service loop group.
<Sysname> system-view
[Sysname] link-aggregation group 5 service-type tunnel
1.1.11 port link-aggregation group
Syntax
port link-aggregation group agg-id
undo port link-aggregation group
View
Ethernet port view
Parameters
agg-id: Link aggregation group ID.
Description
Use the port link-aggregation group command to add the Ethernet port to the
specified link aggregation group (manual or static LACP) or service loop group.
Use the undo port link-aggregation group command to remove the Ethernet port
from the specified aggregation group or service loop group.
Related commands: display link-aggregation verbose.
Examples
# Add port Ethernet 2/0/1 to link aggregation group 22.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] port link-aggregation group 22