H3C S7500E Series

Command Manual – QinQ-BPDU Tunneling
H3C S7500E Series Ethernet Switches Chapter 1 QinQ Configuration Commands
1-8
[Sysname] traffic behavior behavior1
[Sysname-behavior-behavior1]
1.1.10 traffic classifier
Syntax
traffic classifier classifier-name [ operator { and | or } ]
undo traffic classifier classifier-name
View
System view
Parameters
and: Specifies the relationship between the match criteria in the specified class as
logical AND. That is, a packet belongs to the class only when it matches all the match
criteria defined in the class.
or: Specifies the relationship between the match criteria in the class as logical OR. That
is, a packet belongs to the class if it matches a match criterion defined in the class.
classifier-name: Class name, a string of 1 to 31 characters.
Description
Use the traffic classifier command to create a class. This command also leads you to
class view.
Use the undo traffic classifier command to remove a class.
By default, a packet belongs to the class only when it matches all match criteria defined
in the class.
Examples
# Create the class class1.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1]