H3C S7500E Series

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-15
Description
Use the modem auto-answer command to configure the switch-side modem to
operate in the auto-answer mode.
Use the undo modem auto-answer command to restore the default.
By default, the switch-side modem operates in the manual answer mode.
Examples
# Configure the switch-side modem to operate in the auto-answer mode.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] modem auto-answer
1.1.16 modem timer answer
Syntax
modem timer answer seconds
undo modem timer answer
View
AUX interface view
Parameters
seconds: Timeout time in seconds, ranging from 1 to 60. The default is 30 seconds.
Description
Use the modem timer answer command to set the maximum amount of time that the
modem waits for the carrier signal after the off-hook action during incoming call
connection setup.
Use the undo modem timer answer command to restore the default.
Examples
# Set the maximum amount of time that the switch-side modem waits for the carrier
signal after the off-hook action to 45 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] modem timer answer 45