Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 3 IGMP Configuration Commands
3-3
3.1.2 display igmp group port-info
Syntax
display igmp group port-info [ vlan vlan-id ] [ slot slot-id ] [ verbose ]
View
Any view
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094. If you do not specify a VLAN, this command
will display the information of Layer 2 ports in all VLANs.
slot slot-id: Displays the Layer 2 port information on the specified card.
verbose: Displays the detailed information about Layer 2 ports.
Description
Use the display igmp group port-info command to view IGMP Layer 2 port
information.
Examples
# View detailed information of IGMP Layer 2 ports.
<Sysname> display igmp group port-info verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):2.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port.
Eth1/0/2 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(1.1.1.1, 224.1.1.1):
Attribute: Host Port
Host port(s):total 1 port.
Eth1/0/1 (D) ( 00:03:23 )
MAC group(s):
MAC group address:0100-5e01-0101
To Next Page
Loading...
Need help?
General
