To Next Page

To Previous Page

Command Manual – Login

H3C S7500E Series Ethernet Switches

Chapter 1 Commands for Logging into an

Ethernet Switch

1-28

Examples

# Make the switch to operate as a Telnet Server.

<Sysname> system-view

[Sysname] telnet server enable

% Start Telnet server

# Disable the switch from operating as a Telnet server.

[Sysname] undo telnet server enable

% Close Telnet server

1.1.31 terminal type

Syntax

terminal type { ansi | vt100 }

undo terminal type

View

User interface view

Parameters

ansi: Specifies the terminal display type to ANSI.

vt100: Specifies the terminal display type to VT100.

Description

Use the terminal type command to configure the type of terminal display .

Use the undo terminal type command to restore the default.

Currently, the system support two types of terminal display : ANSI and VT100.

By default, the terminal display type is ANSI. The device must use the same display

type as the terminal. If the terminal uses VT 100, the device should also use VT 100.

Examples

# Set the terminal display type to VTY 100.

<Sysname> system-view

System View: return to User View with Ctrl+Z.

[Sysname] user-interface vty 0

[Sysname-ui-vty0] terminal type vt100

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series