H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-30
3.1.24 ospfv3 area
Syntax
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
View
Interface view
Parameters
process-id: OSPFv3 process ID, in the range 1 to 65535.
area-id: Area ID, a decimal integer (in the range of 0 to 4294967295) that is translated
into IPv4 address format by the system or an IPv4 address.
instance-id: Instance ID of an interface, in the range 0 to 255. The default is 0.
Description
Use the ospfv3 area command to enable an OSPFv3 process on the interface and
specify the area for the process.
Use the undo ospfv3 area command to disable an OSPFv3 process.
OSPFv3 is not enabled on an interface by default.
Examples
# Enable OSPFv3 process 1 on an interface that belongs to instance 1 and specify area
1 for the process.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 1 area 1 instance 1
3.1.25 ospfv3 cost
Syntax
ospfv3 cost value [ instance instance-id ]
undo ospfv3 cost [ instance instance-id ]
View
Interface view
Parameters
value: OSPFv3 cost of the interface, in the range 1 to 65535.
instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English