H3C S7500E Series Command Manual

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-18
Parameters
None
Description
Use the display ipv6 routing-table command to display brief routing table information,
including destination IP address and prefix, protocol type, priority, metric, next hop and
outbound interface.
The command displays only active routes, namely, the brief information about the
current optimal routes.
Examples
# Display brief routing table information
<Sysname> display ipv6 routing-table
Routing Table :
Destinations : 1 Routes : 1
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0
Interface : InLoop0 Cost : 0
Table 1-9 Description on the fields of the display ipv6 routing-table command
Field Description
Destination Destination IPv6 address
NextHop Next hop
Preference Routing preference
Interface Outbound interface
Protocol Routing protocol of the route
Cost Routing cost
1.1.12 display ipv6 routing-table acl
Syntax
display ipv6 routing-table acl acl6-number [ verbose ]
View
Any view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English