EasyManuals Logo

H3C S7500E Series Command Manual

H3C S7500E Series
1565 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1514 background imageLoading...
Page #1514 background image
Command Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands
1-12
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] ring 20 node-mode edge common-port gigabitethernet
3/0/1 edge-port gigabitethernet 3/0/2
# Specify the device as the assistant edge node of primary ring 20 in RRPP domain 1,
GigabitEthernet 3/0/1 as the common port and GigabitEthernet 3/0/2 as the edge port.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] ring 20 node-mode assistant-edge common-port
gigabitethernet 3/0/1 edge-port gigabitethernet 3/0/2
1.1.7 ring enable
Syntax
ring ring-id enable
undo ring ring-id enable
View
RRPP domain view
Parameters
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the ring enable command to enable the RRPP ring.
Use the undo ring enable command to disable the RRPP ring.
By default, the RRPP ring is disabled.
Note that:
z To enable subrings, you must first enable the primary ring before enabling
subrings.
z You must first disable all the subrings in the RRPP domain and then disable the
primary ring.
z To activate the RRPP domain, RRPP protocol and the RRPP ring must be
enabled simultaneously.
Related commands: rrpp enable.
Examples
# Enable RRPP ring 10 in RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals