Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-20
virtual-mac: Associates the virtual MAC address of the router with the virtual IPv6
address of the standby group.
Description
Use the vrrp ipv6 method command to set the mappings between the virtual IPv6
addresses and the MAC addresses of the standby groups.
Use the undo vrrp ipv6 method command to restore the default mapping.
By default, the virtual MAC address of the standby group is associated with the virtual
IP address.
Configure the mapping between the virtual IPv6 address and the MAC address before
configuring a standby group. Otherwise, your configuration will fail.
Examples
# Associate the virtual IP address of the standby group with the real MAC address of
the routing interface.
<Sysname> system-view
[Sysname] vrrp ipv6 method real-mac
1.2.6 vrrp ipv6 ping-enable
Syntax
vrrp ipv6 ping-enable
undo vrrp ipv6 ping-enable
View
System view
Parameters
None
Description
Use the vrrp ipv6 ping-enable command to enable users to ping the virtual IPv6
addresses of standby groups.
Use the undo vrrp ipv6 ping-enable command to disable the virtual IPv6 addresses
of standby groups from being pinged.
By default, the virtual IP addresses of standby groups can be pinged.
Perform this configuration before configuring a standby group.
Examples
# Enable users to ping the virtual IPv6 addresses of standby groups.
To Next Page
Loading...
Need help?
General
