H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-1
Chapter 4 PIM Configuration Commands
 Note:
The term “router” in this document refers to a router in a generic sense or a Layer 3
switch running the PIM protocol.
4.1 PIM Configuration Commands
4.1.1 auto-rp enable
Syntax
auto-rp enable
undo auto-rp enable
View
PIM view
Parameters
None
Description
Use the auto-rp enable command to enable auto-RP.
Use the undo auto-rp enable command to disable auto-RP.
By default, auto-RP is disabled.
Related commands: static-rp.
Examples
# Enable auto-RP.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] auto-rp enable