Command Manual – Portal
H3C S7500E Series Ethernet Switches Chapter 1 Portal Configuration Commands
1-15
1.1.11 portal free-rule
Syntax
portal free-rule rule-number { destination { any | ip { ip-address mask { mask-length |
netmask } | any } } | source { any | [ interface interface-type interface-number | ip
{ ip-address mask { mask-length
| netmask } | any } | mac mac-address | vlan vlan-id ]
* } } *
undo portal free-rule { rule-number | all
}
View
System view
Parameters
rule-number: Number for the portal-free rule, in the range 0 to 31.
any: Imposes no limitation on the previous keyword.
ip ip-address: Specifies an IP address.
mask { mask-length
| netmask }: Specifies the mask of the IP address, which can be in
dotted decimal notation or an integer in the range 0 to 32.
interface interface-type interface-number: Specifies a source interface.
mac mac-address: Specifies a source MAC address in the format of H-H-H.
vlan vlan-id: Specifies a source VLAN ID. The value range is from 1 to 4094.
all: Specifies all portal-free rules.
Description
Use the portal free-rule command to configure a portal-free rule and specify the
source filtering condition and/or destination filtering condition.
Use the undo portal free-rule command to remove a specified portal-free rule or all
portal-free rules.
Related commands: display portal free-rule.
 Note:
z If you specify both the source IP and source MAC address information in a
portal-free rule, the IP address must be a host address with a mask of 32 bits;
otherwise, the specified MAC address will be neglected.
z You cannot configure two portal-free rules with the same filtering conditions.
Otherwise, the device will prompt that the portal-free rule already exists.
To Next Page
Loading...
Need help?
General
