H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 1 Static Routing Configuration Commands
1-1
Chapter 1 Static Routing Configuration
Commands
 Note:
The term “router” in this document refers to a router in a generic sense or a Layer 3
switch.
1.1 Static Routing Configuration Commands
1.1.1 delete static-routes all
Syntax
delete static-routes all
View
System view
Parameters
None
Description
Use the delete static-routes all command to delete all static routes.
When you use this command to delete static routes, the system will prompt you to
confirm the operation before deleting all the static routes.
Related commands: display ip routing-table, ip route-static.
Examples
# Delete all static routes on the router.
<Sysname> system-view
[Sysname] delete static-routes all
This will erase all ipv4 static routes and their configurations, you must reconf
igure all static routes
Are you sure?[Y/N]:Y

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English