H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-1
Chapter 4 IS-IS Configuration Commands
 Note:
The “router” in this document refers to a router in a generic sense or an Ethernet switch
running routing protocols.
4.1 IS-IS Configuration Commands
4.1.1 area-authentication-mode
Syntax
area-authentication-mode { simple | md5 } password [ ip | osi ]
undo area-authentication-mode
View
IS-IS view
Parameters
simple: Specifies to send the password in plain text.
md5: Specifies to send the password encrypted with MD5.
password: Password to be set. For simple authentication mode, the password must be
plain text. For md5 authentication mode, the password can be either plain text or
ciphertext. A plaintext password can be a string of up to 16 characters, such as user918.
A cipher password must be a ciphertext string of up to 24 characters, such as
(TT8F]Y\5SQ=^Q`MAF4<1!!.
ip: Specifies the system to check the configuration for the corresponding field of IP in
LSP.
osi: Specifies the system to check the configuration for the corresponding field of OSI
in LSP.