Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 3 Voice VLAN Configuration Commands
3-5
View
Ethernet port view
Parameters
None
Description
Use the voice vlan enable command to enable the voice VLAN feature on an Ethernet
port.
Use the undo voice vlan enable command to disable the voice VLAN feature on an
Ethernet port.
No voice VLAN is enabled on a port by default.
z Under automatic mode, only The Trunk or Hybrid port can be configured with the
voice VLAN feature. The Access port cannot be configured with this feature.
z Before enabling the voice VLAN feature on a port, ensure that its is enabled
globally first
z Only after the voice VLAN feature is enabled under both system view and Ethernet
port view will it functions properly.
Examples
# Enable the voice VLAN feature on the port Ethernet 2/0/1.
<Sysname> system-view
[Sysname] voice vlan 2 enable
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] voice vlan enable
3.1.6 voice vlan mac-address
Syntax
voice vlan mac-address mac-addr mask oui-mask [ description text ]
undo voice vlan mac-address oui
View
System view
Parameters
mac-addr: MAC address, in the format of H-H-H, such as 1234-1234-1234.
mask oui-mask: Specifies the valid length of the OUI address, represented in mask, in
the format of H-H-H, from left to right are consecutive fs and 0s, for example,
ffff-f000-0000.
To Next Page
Loading...
Need help?
General
