Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 3 Voice VLAN Configuration Commands
3-6
description text: Specifies a string that describes the OUI address. The string is of 1 to
30 characters and is case sensitive.
oui: Deletes an OUI address that is in the format H-H-H, such as 1234-1200-0000,
which is the logic AND result of mac-addr and oui-mask. Using the display voice vlan
oui command can display OUI address information. The OUI address cannot be a
broadcast, multicast or address of all 0s or all fs.
Description
Use the voice vlan mac-address command to make a specified OUI address
identified by the voice VLAN.
Use the undo voice vlan mac-address command to remove an OUI address from
being identified by the voice VLAN.
A maximum of 16 OUI addresses can be supported by the system.
By default, default OUI addresses, which can be removed or then added, as illustrated
in the following table.
Table 3-3 Default OUI addresses
Number OUI Description
1 0001-e300-0000 Siemens phone
2 0003-6b00-0000 Cisco phone
3 0004-0d00-0000 Avaya phone
4 0060-b900-0000 Philips/NEC phone
5 00d0-1e00-0000 Pingtel phone
6 00e0-7500-0000 Polycom phone
7 00e0-bb00-0000 3com phone
Related commands: display voice vlan oui.
Examples
# Configure the OUI address as 1234-1234-1234, the mask as ffff-ff00-0000, and the
descriptive string as phone A, that is, voice packets from Phone A with source MAC
address being 1234-1234-1234 can pass through the voice VLAN.
<Sysname> system-view
[Sysname] voice vlan mac-address 1234-1234-1234 mask ffff-ff00-0000
description PhoneA
# Display OUI address information.
<Sysname> display voice vlan oui
Oui Address Mask Description
To Next Page
Loading...
Need help?
General
