Command Manual – ACL
H3C S7500E Series Ethernet Switches Chapter 1 ACL Configuration Commands
1-1
Chapter 1 ACL Configuration Commands
1.1 Common Configuration Commands
1.1.1 display acl resource
Syntax
display acl resource [ slot slot-id ]
View
Any view
Parameters
slot-id: Number of the slot.
Description
Use the display acl resource command to display the ACL uses on a switch.
Note that:
z Using the command with a specified a slot will display the ACL uses of that slot.
Otherwise, the ACL uses of all slots of the device will be displayed.
z If the board specified by the slot number is not in place or not working normally,
this command will display nothing.
Examples
# Display the ACL uses of all slots on the switch.
<Sysname> display acl resource
Interface:
Eth2/0/1 to Eth2/0/24
------------------------------------------------------------------------
Type Total Reserved Configured Remaining
------------------------------------------------------------------------
IFP ACL 1024 0 50 974
IFP Meter 512 0 44 468
IFP Counter 512 0 0 512
Interface:
Eth2/0/25 to Eth2/0/48
------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
